- CORRECT FREQUENCY allows to enter the actual measured frequency of the 10MHz CAL OUTPUT. Make sure you have set the CAL OUTPUT to 10 MHz and measured the output with a good frequency counter.
- MINIMUM GRID LINES sets the minimum grid lines to show
- CLEAR CONFIG enter 1234 to reset the configuration to factory defaults. After clearing the configuration the tinySA will restart for the new settings to take effect.
- PULSE HIGH enables a trigger signal from the high input at the start of each low input sweep.
- CONNECTION activates a sub menu for selecting the connection to the tinySA
- USB selects the USB interface for connection
- SERIAL selects the internal serial interface for connection
- SERIAL SPEED enables the selection of the speed of the serial interface
- BACK moves back to the second settings menu
The CORRECT FREQUENCY setting only impacts the low and high input and output frequencies. The Cal output frequencies do NOT change after setting the CORRECT FREQUENCY.