tinySA | Main / Sweep settings

SPAN sets the span of the sweep. Set to zero to disable the sweep
LEVEL CHANGE sets the delta to the set level at the end of the sweep. Set to zero to disable the sweep. Example: LEVEL set of -60, LEVEL SWEEP set to 40. This will start each sweep at -60dBm and increase during the sweep until reaching -20dBm at the end of each sweep. LEVEL CHANGE is only available in low output mode.
SWEEP TIME sets the time in seconds of a sweep. Setting the time to zero sets maximum sweep speed.
SWEEP POINTS activates a submenu allowing to set the number of steps in the sweep to 51,101,145 or 290
BACK moves back to the output menu