• View
• Edit
• History
• Print

Sweep settings

• SPAN sets the span of the sweep. Set to zero to disable the sweep
• LEVEL CHANGE sets the delta to the set level at the end of the sweep. Set to zero to disable the sweep. Example: LEVEL set of -60, LEVEL SWEEP set to 40. This will start each sweep at -60dBm and increase during the sweep until reaching -20dBm at the end of each sweep. LEVEL CHANGE is only available in low output mode.
• SWEEP TIME sets the time in seconds of a sweep. Setting the time to zero sets maximum sweep speed.
• SWEEP POINTS activates a submenu allowing to set the number of steps in the sweep to 25, 50, 100, 200, 290 or 450 points
• START SWEEP starts the sweep when either span or level change has been set.
• EXTERNAL GAIN sets the external gain (positive) or attenuation (negative) correction.
• BACK moves back to the output menu