Recent Changes - Search:

edit SideBar

Trigger modes

Triggering can be done in frequency domain (e.g. scanning a certain span) or in time domain (e.g. with zero span). Triggering in frequency domain can be slow due to the time required to scan the frequency span.

  • AUTO is the normal spectrum analyzer scanning mode, triggering is not active.
  • NORMAL will display a new scan as soon as a signal in the scan causes a trigger event.
  • SINGLE will wait for a signal to cause a trigger event and display the scan. Restart the waiting for an event by activating SINGLE again.
  • LEVEL opens a sub-menu for the trigger level:
    • TRIGGER LEVEL activates a keypad for entering the trigger level when multi-band mode is not active
    • TRIGGER TRACE x selects a trace (1-4) to use as the trigger level, showing the trace table menu
  • EDGE toggles the trigger edge direction: UP (level crosses from below to above) or DOWN (level crosses from above to below)
  • TRIGGER toggles the trigger position on the screen: PRE, MID or POST. When using MID or POST trigger you can capture and display the signal before the trigger event happened
  • INTERVAL sets the time grid interval for starting a scan. Set to zero to deactivate. Useful for fixed-interval repetitive events.
  • BEEP outputs a beep via the audio output whenever a trigger level is exceeded. Also works in AUTO mode.
  • AUTO SAVE when enabled saves the scan to SD card when the trigger level is exceeded.
  • BACK returns to the Level menu

The active trigger level is shown on the screen as a blue line and in the status at the left. The trigger level in the status is shown in red when waiting for the trigger to happen and in green when a single trigger happened

The trigger level can also be changed by dragging the blue line up or down with the touch screen. In multi band mode every band has its own trigger line, each one can be dragged. The LEVEL button shows the trigger level in the selected unit.

Edit - History - Print - Recent Changes - Search
Page last modified on October 22, 2022, at 08:17 AM