Recent Changes - Search:

edit SideBar

Expert Config Menu

Allows the setting of various internal parameters. Do not change anything unless you know what you are doing.

  • PROGRESS BAR controls the display of the green progress bar when scanning is slow.
  • DIRECT MODE enables a special mode for measuring close to the IF frequency.
  • LINEAR AVERAGING enables linear power averaging (standard for power calculations).
  • AUDIO AGC keeps the audio level of the listen mode constant (enabled by default). When disabled, the PCB edge point PA4 has in listen mode a voltage that is linear with the signal level in dBm: useful to use the tinySA Ultra as a selective power meter.
  • HARMONIC sets the harmonic to use in harmonic mode.
  • FREQ CORR sets the frequency correction in ppb.
  • NF allows entering the noise figure of the tinySA Ultra.
  • DUMP FIRMWARE writes the firmware to the SD card.
  • HAM BANDS enables the gray shading showing the location of the ham bands.
  • SHOW BANDS highlights the bands of the MULTI BAND table with their names while multi band is off, for example frequency bands loaded from a .bnd file with SD->BANDS.
  • INTERNALS supports setting some internal parameters.
  • BACK returns to the previous menu
Edit - History - Print - Recent Changes - Search
Page last modified on November 24, 2022, at 10:01 AM